I need to operate a 4x4 matrix to find its inverse in my firmware. I was trying to see if there was a function from any TI library can be used for that. So far, I haven't found any. 1. Please confirm ...

I am using PIC32MZ2064DAS169i micro controller with DP83848 PHY. I have interfaced the DP83848 PHY driver library in MPLAB version 6.20 harmony library. When i am ...

We have question from our customer regards to bq25629 application. Hope you can help, thanks in advance. Our customer is looking at using bq25629 as battery charging for pointing device (Mouse) design ...

I have received a .DAT file from the mmWave Visualizer. How can I open/analyze this file using Matlab? I am trying to get the points information, is there has matlab or python code?

When the Init bit (CCCR.INIT) is cleared by your code, the MCAN module will then wait for 129 occurrences of Bus Idle (129 × 11 consecutive recessive bits) before resuming normal operation. After the ...

I am looking for software help on a CAN interface that is on the TI CP3UB26 microcontroller as well as on the NatSemi/TI CR16 family. Does TI have any software drivers for this CAN peripheral? Thank ...

our soc application need to open "/dev/dma_heap/carveout_edgeai_shared-memories", but in the development board, there is just 'linux,cma' and 'system' node in /dev ...

Note - all references to issuing commands and displaying data refer to the use of BQStudio and an EV2400. Also just to provide context, I have a BQ27520EVM connected to a BQ41Z50EVM, and my ultimate ...

The open-loop gain in the simulation result (59.9V/mV) is smaller than the minimum value (70V/mV) in the datasheet. Does this mean that the gain in the SPICE model is smaller than the gain in the ...

I have take a look to the following TI documents C2000 F28P65x Series LaunchPad Development Kit TMS320F28P65x Real-Time Microcontrollers , Technical Reference Manual F28P65X Control Card and I would ...

We are using TCAN1145-Q1 to judge it is wake up frame from the network or not by CANINT register bit. While we found when there are other nodes receiving WUF, this TCAN1145 node cannot assert register ...

Reg63 ”DAC Channel Volume Control's Soft-Step control”...Soft-Stepping is 1 step per 1 or 2 DAC Word Clock I would like to check whether there is any pop noise when switching from maximum volume to ...